September, 2016 | Wattics Docs

Connect your Accuenergy AcuVIM-II meters to Wattics with the Octopus

Posted on September 22, 2016July 25, 2018 by Anthony Schoofs

1 Electrical Wiring Make sure that all devices are powered off before any wiring is done. The Acuvim II’s RS485 terminals of communication are A, B, and S (14, 15, 16): A is differential signal + B is differential signal – S is connected to the shield of the twisted…

Connect your Carlo Gavazzi EM21 meters to Wattics with the Octopus Gateway

Posted on September 13, 2016July 25, 2018 by Anthony Schoofs

1 Electrical Wiring Isolate unused RS485 cable wires before powering up the Octopus to avoid unexpected shorts. Switch on the resistor for daisy chain installations. Write down your meter’s Modbus/rs485 settings: Modbus address / baud rate / number of bits / parity / stop bits For more information check the following…